6 steps to install LED Panel Light Suspending

There are more than 7 fixing ways to install LED Panel Lights in WAHLL Lighting’s LED Panel Light. Like Suspending, Built in, Mounting, Jump ring…
Here follows is the 6 stpes to intall LED Panel Light.

Step 1: Pull the LED driver securing pin up which on the back of LED Panel Light;

Pull Pin-LED Panel Light Installation

Step2: Fix the LED driver by the hole of the LED diver base with the securing pin;

Fix LED Dirver-LED Panel Light Installation

Step3: Pass through the 4 handing holes by the 4 suspended cable line; The little hammer will stuck by the end;

Suspended Candle-LED Panel Light Installation

Step4: Mounting the 4 connecting bridge to the ceiling with Screw. The 4 connecting bridge fixing positing should correspond to 4 handing holes on the LED Panel Light. Push another end without the hammer of suspended cable into the hole of hoist clamp.